Safety considerations
LOGIQ e – Basic Service Manual 1-19
5461614-100 English Rev. 6
Safety considerations
Introduction
The following safety precautions must be observed during all
phases of operation, service and repair of this equipment.
Failure to comply with these precautions or with specific
warnings elsewhere in this manual, violates safety standards of
design, manufacture and intended use of the equipment.
Contents in this Section
• ‘Human Safety’ on page 1-19
• ‘Mechanical safety’ on page 1-22
• ‘Electrical safety’ on page 1-24
• ‘Battery Safety’ on page 1-26
Human Safety
• Operating personnel must not remove the system covers.
• Servicing should be performed by authorized personnel
only.
Only personnel who have participated in a LOGIQ e Training
Seminar are authorized to service the equipment.
DANGER
DANGEROUS VOLTAGES, CAPABLE OF CAUSING
DEATH, ARE PRESENT IN THIS EQUIPMENT. USE
EXTREME CAUTION WHEN HANDLING, TESTING
AND ADJUSTING.
WARNING
If the covers are removed from an operating LOGIQ e, some
metal surfaces may be warm enough to pose a potential heat
hazard if touched, even while in shutdown mode.
To Next Page
Loading...
Need help?
General
