Clean and Disinfect
Chapter 6: General Procedures
Page 6 - 2 CareAssist® and CareAssist® ES Bed Service Manual (MAN330 REV 4)
Do not use harsh cleaners, solvents, or detergents. Equipment damage
could occur.
Make sure the bed frame is dry before you put the mattress on the bed.
Failure to do so could cause equipment damage.
Clean and disinfect surfaces with nano Ag+™ Technology as you would other
surfaces. This product is not intended to protect users or others against
bacteria, viruses, germs, or other disease organisms. Always disinfect
Hill-Rom surfaces throroughly after each use according to facility protocol.
Refer to “Clean” and Disinfect” below.
Clean
1. Unplug the bed.
2. Remove all linens.
3. Use these to clean the bed:
• A soft cloth soaked with warm water and a facility-approved general
cleaning soap/detergent solution. Make sure the cloth is not so wet as to
cause the cleaning solution to pool or flood on the mattress or other bed
components.
• A soft brush to remove stains and resistant soil. Do not use harsh or
abrasive cleansers, solvents, or scouring pads.
To Next Page
Loading...
Need help?
General
