IDS X Series Training Manual

100
IDS X-Series Training v2.7
Option 23 - Button Properties
A button can be changed from the default settings by changing the properties.
Changing a button’s property example:
Option 24 - Relay Properties
The following properties can be set:
Example:
Option 25 - Relay Pulse Time
The default pulse time is 1.5 seconds.
When entering the time, enter in the following format “mmss”.
Example:
Zone LED
Property
1
Relay 1
2
Relay 2
3
Arm / Disarm
4
Stay Arm
5
Panic
Instruction
Key presses
Press and hold the [*] key for 3 seconds
[*]
Enter the master code, followed by the [*] key
[1][2][3][4] [*]
Enter the value to change the button properties, followed by the [*] key
[2][3] [*]
Enter the remote receiver ID that the transmitter will be taught to, followed by the [*] key
[1] [*]
Enter the button number, followed by the [*] key
[2] [*]
Enter the property number, followed by the [*] key
[1] [*]
When complete press the [#] key
[#]
This will leave you in the remote receiver menu
Zone
LED
Property
Description
1
Secure
When power is lost the relay rests in the opposite position. I.e. Normally closed will rest in
normally open
2
Panic
When a panic is triggered via a button, or the 3 second hold option, the relay will trigger
3
Retrigger
This stops the relay from retriggering for 20 seconds after an initial trigger
4
Pulse
The relay will trigger and then reset without any intervention
Instruction
Key presses
Press and hold the [*] key for 3 seconds
[*]
Enter the master code, followed by the [*] key
[1][2][3][4] [*]
Enter the value to change the relay properties, followed by the [*] key
[2][4] [*]
Enter the remote receiver ID that the transmitter will be taught to, followed by the [*] key
[1] [*]
Enter the relay number, followed by the [*] key
[2] [*]
Enter the property number, followed by the [*] key
[2] [*]
When complete press the [#] key
[#]
This will leave you in the remote receiver menu
Instruction
Key presses
Press and hold the [*] key for 3 seconds
[*]
Enter the master code, followed by the [*] key
[1][2][3][4] [*]
Enter the value to change the relay pulse time, followed by the [*] key
[2][5] [*]
Enter the remote receiver ID that the transmitter will be taught to, followed by the [*] key
[1] [*]
Enter the relay number, followed by the [*] key
[1] [*]
Enter the pulse time in mmss, followed by the [*] key
[0][0][1][0] [*]
When complete press the [#] key
[#]
This will leave you in the remote receiver menu
This table shows the properties that can be
allocated to a button

IDS X Series Specifications

General

Brand	IDS
Model	X Series
Category	Keypad
Language	English