IDS X Series Training Manual

92
IDS X-Series Training v2.7
Option 4 - Delete a User Code via Slot Number
If the original code is not known but the user’s slot number is option 4 allows deleting via slot number.
Example:
Option 5 - View a User Codes Slot Number
If the user code is known but you want to know which slot that code is, this option will display the slot
number once the original code is entered.
Example:
Instruction
Key presses
Press and hold the [*] key for 3 seconds
[*]
Enter the master code, followed by the [*] key
[1][2][3][4] [*]
Enter the value to call up the slot number of a user code, followed by the [*] key
[5] [*]
Now enter the user code, followed by the [*] key
[5][8][7][9] [*]
When complete press the [#] key
[#]
This will leave you in the master menu
Option 10 - Editing User Code Properties
By default when entering user codes the code is an arm disarm code. There are a number of other
options that can be added to a code. The table below describes each of these options and indicates
the value to enter to add the property.
Note: Any code between 2 & 128 that is a “master code” can only add users to the partition that it
belongs too. The default Master code can add to any partition.
Example:
Instruction
Key presses
Press and hold the [*] key for 3 seconds
[*]
Enter the master code followed, by the [*] key
[1][2][3][4] [*]
Enter the value to delete a user code via a slot number, followed by the [*] key
[4] [*]
Now enter the user code to be deleted, followed by the [*] key
[5][8] [*]
When complete press the [#] key
[#]
This will leave you in the master menu
Zone LED
Property
Explanation
1
Master User
Adds, deletes and changes user settings
2
Duress Code
A code that works exactly like a normal code, but sends a panic
signal to the control room.
3
Arm to Disarm Code [Maid’s
Code]
This code can only disarm the system if used to arm the system
4
Arm Code
Can only arm the system
5
Disarm Code
Can only disarm the system
6
Global Arm/Disarm
Can arm or disarm any partition
7
Programmable Output Code
This option will trigger an output when entered
8
Allow bypassing
If enabled the user can bypass zones if bypass with user code is
enabled by the installer
9
Voice Module Login
If enabled the user can access the panel via the voice module
Instruction
Key presses
Press and hold the [*] key for 3 seconds
[*]
Enter the master code, followed by the [*] key
[1][2][3][4] [*]
Enter the value to edit user code properties, followed by the [*] key
[1][0] [*]
Now enter the user code or user slot number, followed by the [*] key
[2][5][8][0] [*]
Above is a table of all the user properties, we will make a Duress Code (followed by the [*]
key)
[2] [*]
When complete press the [#] key
[#]
This will leave you in the master menu

IDS X Series Specifications

General

Brand	IDS
Model	X Series
Category	Keypad
Language	English