IDS X-Series Training v2.7
To check the PGM status of PGM 4 you will use the following information:
Code – 1234 (a valid user code in partition 1)
Command – PGM
Extended Command – Status
Data – 4 (PGM number)
The SMS should look like this:
1234 pgm status 4
All status commands:
Retrieve the status of all partitions
Retrieve the status of P1
Retrieve the status of P3 & P6
Retrieve the status of zones in partition 1
Retrieve the status of zones in partition 1 & 3
Retrieve bypass status of zone 1
Retrieve status of “Lounge”
3. Command Table
Add phone number as an Master
number
Add phone number as an Arm number
Add phone number as a Reporting
number
Turn on reporting for partition events
Turn off reporting for global events
Turn on reporting for partition and global
events
Turn on reduced reporting
Turn on raw data reporting
Increase the reporting threshold to 50
SMSes
Stay arm P2 in stay profile 3
Stay arm P1 & P4 in stay profile 1
To Next Page
Loading...
Need help?
General
