IDS X-Series Training v2.7
Increase the reporting
threshold to 50 SMSes
Decrease the reporting
threshold to 14 SMSes
2.5. Arm/Disarm
Master and Arming phone numbers are able to arm or disarm the X-Series Alarm Panel in multiple profiles.
Arming the panel requires a valid user code for the partition you want to arm/disarm.
To away arm partition 1 you will use the following information:
Code – 1234 (a valid user code in partition 1)
Command – Arm
Extended Command – *
Not needed
Data – P1 (Partition number)
The SMS should look like this:
1234 arm p1
To arm partition 3 in stay profile 2 you will use the following information:
Code – 1234 (a valid user code in partition 1)
Command – Arm
Extended Command – S2 (Stay Profile number)
Data – P3 (Partition number)
The SMS should look like this:
1234 arm s2 p3
All arm/disarm commands:
Stay arm P2 in stay profile 3
Stay arm P1 & P4 in stay profile 1
2.6. Bypass/Unbypass
When needed you are able to send a command to bypass or unbypass a specific zone/s. You must
specify which zones to bypass in the data field.
To bypass zone 3 you will use the following information:
Code – 1234 (a valid user code)
Command – Bypass
Extended Command – *
Not needed
Data – 3 (Zone number)
To Next Page
Loading...
Need help?
General
