IDS X-Series Training v2.7 | Contact ID Zone Reporting
Contact ID Zone Reporting
This is the complete list of values that can be entered into locations 304 to 335 to extend the Contact ID reporting.
Panel programming changed Zone
Battery test failure Zone
Battery Missing/Dead Zone
Power Supply Overcurrent Zone
Duress – Access granted Zone
Duress – Egress granted Zone
Notification Appliance Ckt. # 3 Zone
Notification Appliance Ckt. #4 Zone
System Peripheral trouble Zone
Expansion module failure Zone
Local printer out of paper Zone
Local printer failure Zone
Exp. Module Low Battery Zone
Expansion module failure Zone
Exp. Module self-test fail Zone
RF Receiver Jam Detect Zone
Expansion module tamper Zone
Communication trouble Zone
Sensor Supervision Failure Zone
24 Hour Non-Burglary Zone
Long Range Radio Transmitter fault Zone
Failure to communicate event Zone
Loss of Radio supervision Zone
Loss of central polling Zone
Long Range Radio VSWR problem Zone
Protection loop open Zone
Low bottled gas level Zone
Protection loop short Zone
Exit error alarm (zone) Zone
Carbon Monoxide detected Zone
Hold-up zone trouble Zone
Loss of supervision - RF Zone
Loss of supervision - RPM Zone