Inovance SV820N Series User Manual

- 84 -
4 Operation Panel
4
4.5 User Password
After the user password function (H02-30) is enabled, only the authorized user has the parameter setting
rights; other operators can only view the parameters.
4.5.1 Setting User Password
Thefollowingtakestheoperationofsettingthepasswordto"00001"forexample.
Figure 4-6 Diagramforkeypadoperationofuserpasswordsetting
See parameter
settings for
H02-30
Set passwords
Display
“Er.941”
Valid user
password
Display
“- - - - -”
Display
“done”
Display
“Error”
End
Power On
No
Yes
“SET” button
Power on again
“SET” button
Yes
No
Enter the
password
Is the password
correct?
“MODE” key
Is the last digit
blinking?
Return to the
display
interface for
H02-30
Start
“SET” key
“SET” key
SET
SET
SET
Note
● *1:Ifthelastdigitdoesnotblink,passwordprotectionisenabled.Ifthelastdigitblinks,
password protection is disabled or the correct password has been entered.
● When modifying the user password, enter the current password so that you enable the
parameter setting rights. Enter H02-30 again, and you can set a new password, according to
themethoddescribedintheprecedinggure.
4.5.2 Canceling User Password
Enter the existing user password, and set H02-30 to "00000". Then, the user password is canceled.

Inovance SV820N Series Specifications

General

Brand	Inovance
Model	SV820N Series
Category	Servo Drives
Language	English