Keithley SourceMeter 2410 User Manual

2400 Series SourceMeter
®
User’s Manual Triggering 11-27
Figure 11-11
Operation model for triggering example
A) Turning the SourceMeter OUTPUT ON places it at point A in the flowchart, where it
waits for an external trigger.
B) Pressing STEP takes the Model 7001/2 out of the idle state and places operation at
point B in the flowchart.
C) For the first pass through the model, the scanner does not wait at point B. Instead, it
closes the first channel (point C).
D) After the relay settles, the Model 7001/2 outputs a trigger pulse. Since the instrument is
programmed to scan 10 channels, operation loops back to point B, where it waits for an
input trigger.
E) and F) With the SourceMeter operation at point A, the output trigger pulse from the
Model 7001/2 triggers a measurement of DUT #1 (point E). After the measurement is
complete, the SourceMeter outputs a trigger pulse and then loops back to point A, where it
waits for another input trigger.
Idle
Bypass
B
Wait for
Trigger Link
Trigger
Scan
Channel
C
Output
Trigger
Trigger
D
No
Scanned
10
Channels
?
Yes
7001or 7002
Make
Measurement
Made
10
Measurements
?
SourceMeter
Press STEP to start scan
A
Wait for
Trigger Link
Trigger
E
Output
Trigger
Trigger
F
No
Yes
Idle
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com

Keithley SourceMeter 2410 Specifications

General

Brand	Keithley
Model	SourceMeter 2410
Category	Measuring Instruments
Language	English