2400 Series SourceMeter
®
User’s Manual SCPI Command Reference 18-39
PASS:SOURce2 <NRf> | NDN
:CALCulate2:LIMitx:PASS:SOURce2 <NRf> | <NDN> Set sorting mode pass pattern (x = 2, 3, 5-12)
Parameters <NRf> = 0 to 7 (3-bit) Decimal value
0 to 15 (4-bit) Decimal value
<NDN> = 0 to #b111 (3-bit) Binary value
0 to #b1111 (4-bit) Binary value
0 to #q7 (3-bit) Octal value
0 to #q17 (4-bit) Octal value
0 to #h7 (3-bit) Hexadecimal value
0 to #hF (4-bit) Hexadecimal value
Query :SOURce2? Query programmed source value
Description This command is used to define the 3-bit or 4-bit output pattern for the
Digital I/O Port when a test (limit 2, 3, 5-12) for the sorting mode
passes. Note that the output value can be specified in binary, octal, deci-
mal, or hexadecimal format. Use the table provided in the “Description”
for the :SOURce command to determine the parameter value for the
desired decimal digital output pattern.
STATe <b>
:CALCulate2:LIMit[1]:STATe <b> Control LIMIT 1 test
:CALCulate2:LIMitx:STATe <b> Control LIMIT x test (x = 2, 3, 5-12)
Parameters <b> = 1 or ON Enable specified limit test
0 or OFF Disable specified limit test
Query :STATe? Query state of specified limit test
Description These commands are used to enable or disable LIMIT 1, LIMIT 2,
LIMIT 3, and LIMIT 5 to LIMIT 12 tests. Any limit test not enabled is
simply not performed.
When a limit test is enabled, the Digital I/O port comes under control of
limit tests. That is, the result of the testing process updates the output
pattern on the I/O port.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General
