18-106 SCPI Command Reference 2400 Series SourceMeter
®
User’s Manual
DISable <list>
:STATus:QUEue:DISable <list> Disable messages for Error Queue
Parameters <list> = (numlist)
where numlist is a specified list of messages that you wish to disable for
the Error Queue.
Query :DISable? Query list of disabled messages
Description On power-up, all error messages are enabled and will go into the Error
Queue as they occur. Status messages are not enabled and will not go
into the queue. This command is used to specify which messages you
want disabled. Disabled messages are prevented from going into the
Error Queue.
SYSTem subsystem
The SYSTem subsystem contains miscellaneous commands that are summarized in Table
18-9, SYSTem command summary.
Default conditions
PRESet
:SYSTem:PRESet Return to :SYSTem:PRESet defaults
Description This command returns the instrument to states optimized for front panel
operation. :SYSTem:PRESet defaults are listed in the SCPI tables
(Table 18-1 through Table 18-11).
POSetup
:SYSTem:POSetup <name> Program power-on defaults
Parameters <name> = RST Power-up to *RST defaults
PRESet Power-up to :SYSTem:PRESet defaults
SAV0 Power-up to setup stored at memory
location 0
SAV1 Power-up to setup stored at memory
location 1
SAV2 Power-up to setup stored at memory
location 2
SAV3 Power-up to setup stored at memory
location 3
SAV4 Power-up to setup stored at memory
location 4
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General
