2400 Series SourceMeter
®
User’s Manual Limit Testing 12-21
Figure 12-10
Limits configuration menu tree
Performing front panel limit tests
Perform the basic steps below to run limit tests from the front panel. See “Remote limit
testing,” page 12-23, for remote commands and a programming example.
Step 1: Configure test system.
As previously explained, your test system could be as simple as connecting a DUT to the
SourceMeter (Section 2, “Connections”) or could employ the use of a handler for binning
operations. Adding a scanner to the test system allows you to test multi-element devices
(such as resistor networks).
Step 2: Configure source-measure functions.
Configure the SourceMeter for the desired source-measure operations as follows:
1. Select the desired source function by pressing SOURCE V or SOURCE I.
2. Set the source level and compliance limit to the desired values.
3. Press MEAS V or MEAS I to select the desired measurement function, then choose
the desired measurement range.
Refer to Section 3, “Basic source-measure procedure,” for more information.
CONFIG
LIMIT
DIGOUT
H/W
LIMITS
MODE
SIZE
FAIL
MODE
CONTROL
AUTO
CLEAR
S/W
LIMITS
PASS
EOT
MODE
LIM2,3
LIM5-12
CONTROL
HILIM
LOLIM
SRC MEM
LOC
DIG I/O
PATTERN
/EOT
EOT
/BUSY
BUSY
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General
