2400 Series SourceMeter
®
User’s Manual SCPI Command Reference 18-83
Set delay
NOTE For the Model 2430 Pulse Mode, source delay is not used. Therefore, the follow-
ing commands for source delay are ignored.
DELay <n>
:SOURce[1]:DELay <n> Manually set source delay
Parameters <n> = 0 to 999.9999 Specify delay in seconds
MINimum 0 seconds
MAXimum 999.9999 seconds
DEFault 0 seconds
Query :DELay? Query delay
:DELay? DEFault Query *RST default delay
:DELay? MINimum Query lowest allowable delay
:DELay? MAXimum Query highest allowable delay
Description This command is used to manually set a delay (settling time) for the
source. After the programmed source is turned on, this delay occurs to
allow the source level to settle before a measurement is taken. Note that
this delay is the same for both the I-Source and V-Source.
Do not confuse this source delay with the trigger delay. The source
delay is part of the device action (SDM cycle) while the trigger delay
occurs before the device action. See Section 11, “Trigger models,” for
more information.
Auto delay can instead be used to automatically set the source delay.
(See next command.)
AUTO <b>
:SOURce[1]:DELay:AUTO <b> Enable/disable auto delay for source
Parameters <b> = 0 or OFF Disable auto delay
1 or ON Enable auto delay
Query :AUTO? Query state of auto delay
Description This command is used to enable or disable auto delay. When enabled,
the instrument will automatically select a delay period that is appropri-
ate for the present source/measure setup configuration (Table 3-3).
*RST and SYST:PRES default is ON.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General
