GZD15, WSM GENERAL
G-5
[2] BATTERY
A Take care not to confuse positive and negative terminal posts.
A When removing battery cables, disconnect negative cable
first. When installing battery cables, check for polarity and
connect positive cable first.
A Do not install any battery with capacity other than is specified
(Ah).
A After connecting cables to battery terminal posts, apply high
temperature grease to them and securely install terminal
covers on them.
A Do not allow dirt and dust to collect on battery.
A Take care not to let battery liquid spill on your skin and
clothes. If contaminated, wash it off with water
immediately.
A Before recharging the battery, remove it from the
machine.
A Before recharging, remove cell caps.
A Do recharging in a well-ventilated place where there is no
open flame nearby, as hydrogen gas and oxygen are
formed.
[3] FUSE
A Use fuses with specified capacity.
Neither too large or small capacity fuse is acceptable.
A Never use steel or copper wire in place of fuse.
A Do not install working light, radio set, etc. on machine which is
not provided with reserve power supply.
A Do not install accessories if fuse capacity of reserve power
supply is exceeded.
[4] CONNECTOR
A For connector with lock, push lock to separate.
0000000621E
(1) Fuse (2) Fusible Link
0000000622E
(A) Push
0000000623E
To Next Page
Loading...
Need help?
General
