3 - 24
1
2
3
CHECK Generator (OPTION)
NOTE: Refer to the sticker in the basket for the voltage and intensity supplied by the
electric power socket.
- Switch on the platform. Start the engine.
- Start the generator.
- Plug an electrical appliance into the electric power socket in the basket.
Result:
• The electrical appliance should operate.
- Open the right-hand turntable cover.
- Locate the test button
1
on the generator and press it.
Result:
• The switch
2
must move from the ON position to the OFF position, the indicator
3
should be red.
• The electrical appliance should not operate.
- Push the switch to the ON position.
Result:
• The switch must remain in the ON position, the indicator should be green.
• The electrical appliance should operate.
- Disconnect the electrical appliance.
- Stop the generator.
- Close the right-hand turntable cover panel.
- Stop the engine. Power down the platform.
CLEAN Coolant, air and oil radiators
IMPORTANT
Clean the radiators more often when the platform is operating in a dusty environment.
If there is doubt about the condition of the hoses and hose clamps for the coolant and air radiators, it is essential to
have them replaced by an authorised professional from the Manitou network.
- Open the left-hand turntable cover.
- Open the swivelling engine plate, OCCASIONAL OPERATION.
- Clean the radiators
1
with a small brush to remove the dust.
- Clean them with compressed air, from the inside out.
- Check the condition of the hoses and tightening clamps for the coolant and air
radiators.
- Check the condition of the oil radiator.
- Close the swivelling engine plate, OCCASIONAL OPERATION.
1
To Next Page
Loading...
Need help?
General
