1 - 14
IF THE PLATFORM IS NOT TO BE USED FOR A LONG TIME
INTRODUCTION
The following recommendations are intended to prevent the platform from being damaged when it is withdrawn from service
for an extended period.
IMPORTANT
Procedures to follow if the platform is not to be used for a long time and for starting it up again afterwards must be performed by your dealership.
This period of long-term stoppage must not exceed 12 months.
PREPARING THE PLATFORM
- Clean the platform thoroughly.
- Check and repair any leaks of fuel, oil, water, etc.
- Replace or repair any worn or damaged parts.
- Touch up the paintwork if necessary.
- Make sure the cylinder rods are in the retracted position (if applicable).
- Shut down the platform.
- Release the pressure in the hydraulic circuits.
PROTECTING THE ENGINE (DIESEL PLATFORM)
- Fill the tank with fuel ( 3 - MAINTENANCE).
- Replace the engine oil and oil filter ( 3 - MAINTENANCE).
- Drain and replace the coolant ( 3 - MAINTENANCE).
- Disconnect the battery and store it in a safe place away from the cold, after charging it to a maximum.
- Block the outlet with waterproof adhesive tape.
- Remove the belts and store them in a safe place.
- Disconnect the engine cut-off solenoid on the injection pump and carefully insulate the connection.
BATTERY CHARGING (ELECTRIC PLATFORM)
- In order to preserve battery life and capacity, check them periodically and keep the charge level constant (2-DESCRIPTION).
- Do not leave the battery charger connected during a lightning storm.
PROTECTING THE PLATFORM
- Protect cylinder rods which are not be retracted from corrosion.
- Wrap the wheels.
NOTE: If the platform is to be stored outdoors, cover it with a waterproof tarpaulin.
BRINGING THE PLATFORM BACK INTO SERVICE
DIESEL PLATFORM
- Remove the protection from the cylinder rods and wheels.
- Refit and reconnect the battery.
- Remove the waterproof adhesive tape from the exhaust outlet.
- Empty and replace the fuel and replace the fuel filter (
3 - MAINTENANCE).
- Refit the belts and adjust their tension (3-MAINTENANCE).
- Reconnect the engine cut-off solenoid.
IMPORTANT
Make sure the area is adequately ventilated before starting up the platform.
- Start up the platform, following the safety instructions and regulations.
- Perform the daily maintenance operations ( 3 - MAINTENANCE).
DIESEL AND ELECTRIC PLATFORM
- Lubricate the platform completely (
3-MAINTENANCE).
- Carry out all the lifting system’s hydraulic movements right up to the limit switches for each cylinder.
To Next Page
Loading...
Need help?
General
