Crane operation
11.2 Operation of the rated capacity limiter
Operating Manual GMK6300L 3 112 xxx en 11 - 35
xx.xx.xxxx
The current main boom angle
Shows the current main boom angle in relation to the horizontal. Angles
below the horizontal are displayed with a minus sign, e.g. – 3°.
The current overall height
Overall height = vertical distance between the lower edge of the outrigger
pad and the highest point of the main boom or lattice extension. The
displayed value applies to fully extended outrigger cylinders on the largest
outrigger span.
The value is displayed either in metres (m) or in feet (ft), depending on the
setting.
The current lattice extension angle
– Lattice extension, luffable: Shows the current lattice extension inclination
in relation to the main boom in degrees.
– Lattice extension, can be angled: Shows the angle of the lattice extension
corresponding to the RCL code in degrees.
If the displayed RCL code does not apply to a lattice extension, nothing will
be displayed.
The current slewing angle
Shows the angle of the current superstructure position.
0° means that the superstructure is slewed to the rear.
A full turn from this working position is divided into two semi-circles.
– Angles in the right semi-circle are displayed as positive values
(0° to 180.0°),
– Angles in the left semi-circle are displayed as negative values
(0° to -179.9°).
s
To Next Page
Loading...
Need help?
General
