Crane operation
11.3 Crane operation with main boom
11 - 58 3 112 xxx en Operating Manual GMK6300L
xx.xx.xxxx
Switching on the
auxiliary hoist
After the ignition is switched on, all of the power units will be switched off
and the lamps in the corresponding buttons will light up only dimly.
• Check whether the main hoist is switched off and therefore secured
against unintentional operation.
– The lamp in button (1) should light up only dimly.
– Symbol (2) must be red.
• Press the button (1) once.
– The lamp in button (1) lights up brightly.
– Symbol (2) is green when the auxiliary hoist is switched on.
• On the RCL, check whether the lamp II is on.
If lamp
II flashes, switch over the display; Ã p. 11 - 33.
• Check whether the current reeving of the auxiliary hoist is displayed,
e.g. 10. Correct the reeving if necessary;
à p. 11 - 29.
To Next Page
Loading...
Need help?
General
