Manitowoc Grove TMS9000-2 Series User Manual

Grove Published 02-21-2019, Control # 611-05 3-89
TMS9000-2 OPERATOR MANUAL OPERATING CONTROLS AND INDICATORS
3
• The displays (1, Figure 3-89) and (2) show the current
values.
• Select and confirm the symbol:
• Select and confirm the symbol (7).
Symbol is orange – input on.
To cancel the input – press button (9) once.
• Change the value using buttons (8) or (10).
• Confirm the changed value.
Display – setting the brightness
The brightness of the displays is regulated automatically by
the display, depending on the ambient brightness. You can
set a minimum degree of brightness manually, which is
always observed when the brightness is regulated.
• Display Settings (1, (Figure 3-90)) menu.
• Select the symbol (1, (Figure 3-91)).
• Confirm the selection.
An arrow appears on the left and right of the percentage (2).
• Set the desired minimum brightness.
• Confirm the selection.
The brightness of the display changes while setting and you
can view the set value (0 to 100%) on the display (2).
The brightness set here is the minimum value for automatic
regulation.
NOTE: There is no automatic regulation if you set the
brightness to 100%.
The displays then always show maximum brightness.
You can cancel the entry at any time using the (1,
(Figure 3-92)) or (2) buttons. The settings are then reset.
If the temperature on the display is too high, the brightness is
reduced automatically – lamp (1, (Figure 3-93)) lights up.
When the temperature falls, the specified brightness is
restored – lamp (1) goes out.
3 Interval for windshield wiper
4 Interval for skylight window wiper
1 For the windshield wiper – symbol (5) displayed
2 For the skylight window wiper – symbol (6) displayed
8849-174
FIGURE 3-89
FIGURE 3-90
8854-272a
1
FIGURE 3-91
8882-14
1
2
8854-274
FIGURE 3-92
8854-274

Manitowoc Grove TMS9000-2 Series Specifications

General

Brand	Manitowoc
Model	Grove TMS9000-2 Series
Category	Construction Equipment
Language	English