5-11
TMS9000-2 OPERATOR MANUAL LUBRICATION
Published 02-21-2019, Control # 611-05
Clutch Release Bearing Grease Interval
The transmission has an optional prognostic feature that
notifies the operator when the clutch release bearing needs
greasing. At the appropriate grease interval and after each
engine star, “GI” will momentarily appear in the gear display,
along with an audible tone. This will continue to occur at
each engine start until clutch service has been completed.
NOTE: “GI” stands for GREASE INTERVAL and may be
mis-read as “G1” on the gear display.
The operator can choose to follow this automated lube
schedule or lubricate every 250 hours See “CLUTCH
RELEASE BEARING” on page 9. It is important to reset the
grease interval count every time the release bearing is
greased.
Clutch Release Grease Interval Reset
1. From the OFF position, turn ignition ON without cranking
engine.
2. Move the transmission shift lever to LOW. Do not apply
the brake pedal.
3. Press the manual up-shift button (1) until the gear
display shows “3”(2, Figure 5-3).
4. Press Accelerator to the floor. Gear display will show a
“Down” arrow.
5. Release the Accelerator. Gear display will display an ”0”.
6. Select NEUTRAL.
7. Turn ignition to OFF in order to save the reset.
To Next Page
Loading...
Need help?
General
