SET-UP AND INSTALLATION TMS9000-2 OPERATOR MANUAL
6-6
Published 02-21-2019, Control # 611-05
3. Take the wire rope off the upper boom nose sheave (2)
and place it on the ground on the left side.
4. Replace all retaining rods and secure them with
retaining clips.
Possible reevings on the main boom
NOTE: The maximum load bearing capacity of individual
hook blocks does not correspond to the maximum
load bearing capacity of the TMS9000-2 together
with this hook block. The load bearing capacity of
the TMS9000-2 depends on the rope pull, the
reeving and friction force. It is lower than the load
bearing capacity of the hook block.
NOTE: Please note that the maximum load bearing
capacities already include the weight of the hook
block and the lifting gear. You must subtract these
weights in order to obtain the actual payload.
NOTE: The recommended hook-blocks are designed to be
of sufficient weight to overhaul the rope properly
when using the parts of line required for the allowed
load at the chosen boom length. Operating with a
higher number of parts of line than is necessary for
a particular boom length may result in poor rope
spooling behavior and loosely stored rope, which
can result in future rope damage. If operation in
these extended ranges is desired, extra weight
should be carried by the hookblock or a heavier
hookblock should be used.
With 5 Head Sheaves
5-sheave hook block
Reeving
A 10-parts line
B 9-parts line
C 8-parts line
To Next Page
Loading...
Need help?
General
