OPERATING CONTROLS AND INDICATORS TMS9000-2 OPERATOR MANUAL
3-8 Published 02-21-2019, Control # 611-05
turn regulates the volume of air output of the heater and air
conditioner fan by positioning switch to one of three speeds.
Heater/Air Conditioner Control
The heater/air conditioner control (18) is located on the right
side of the console. Turn the knob fully to the right for
maximum heat and turn the knob fully to the left for maximum
air conditioned air.
Heater/Air Conditioner Select Switch
The heater/air conditioner select switch (19) is located on the
right side of the console. Turn the switch straight up for
heater or to the right for air conditioner.
Ignition Switch
The ignition switch (20) is located on the right side of the
front console. The switch is key operated with three
positions: OFF (vertical position), IGN (position between
vertical and right), and START (right position).
With ignition switches in both cabs in the OFF position, all
electrical power is off except for the headlights, marker lights,
gauge lights, turn and stop light, carrier and superstructure
cab dome lights, superstructure cab work lights, and carrier
horn when one of these battery hot functions are on.
The IGN position energizes all electrical components
including the engine ECM. The START position energizes
the starter relay which in turn energizes the cranking motor
solenoid and cranks the engine for starting. The switch will
return to IGN when the switch is released after the engine is
started. Turn the switch to OFF to shut down the engine.
Parking Brake Control
NOTE: The parking brake must be set before the outrigger
controls will operate.
The parking brake control (21) is located on the right side of
the front console. The control is a push-pull type air valve
used to apply and release the parking brakes on all four rear
wheels. Push to release the parking brakes, pull to apply the
parking brakes.
Dual Air Pressure Gauge
The dual air pressure gauge (22) is located on the right side
of the front console. The gauge is a direct reading pressure
gauge with two indicating pointers, red for the primary
system and green for the secondary system. The gauge has
a dual scale calibrated from 100 to 1000 kPa and 0 to
150 psi. The gauge is connected to each air system
separately through tubing.
Trailing Boom Trailer Emergency Brake
Control (Optional)
The Trailing Boom (Trailer Emergency) brake control (23) is
a push-pull type air valve located on the right side of the front
console. The control is used to set and release the brakes on
the trailing boom trailer. Push the control to release the
brakes, pull the control out to apply the brakes.
Control Panel Indicator and Gauge Display
The indicator and gauge display (24) is located in the center
of the front console. It includes indicator lamps and gauges
that provide information on the engine, transmission, brakes,
and other systems.
To Next Page
Loading...
Need help?
General
