SET-UP AND INSTALLATION TMS9000-2 OPERATOR MANUAL
6-16
Published 02-21-2019, Control # 611-05
Counterweight versions/combinations
Lifting individual counterweight sections
Figure 6-20 identifies the lift sling points for the four different
counterweight plates used on this machine. When lifting the
counterweights onto the carrier platform attach the lifting
sling at the points identified.
Lift the 3,000 lb and two 5,000 lb counterweight sections
using the four casted sling points (1, Figure 6-20). These
WARNING
Crush Hazard!
Only assemble the counterweights in the proper order,
failure to do so could allow the wing weights to fall. The
3000 lb counterweight tray, the two 10,000 lb
counterweight sections, the 3000 lb counterweight
section, and the two 5000 lb counterweight sections must
be rigged BEFORE the wing counterweights can be
assembled.
WARNING
Crush Hazard!
Do not install the bolt pins while the 2250 lb and 4000 lb
wing counterweights are rigged. The wing counterweights
may be pushed off of the stack if the counterweight
assembly is raised and lowered while the bolt pins are
installed.
WARNING
Risk of accidents due to incompletely rigged
machine!
Only operate the truck crane when the auxiliary hoist is
installed. In this way you prevent the RCL using an
incorrect value for calculations and the truck crane
overturning during work.
3,000/5,000 lb CW
1
1
1
1
10,000 lb CW
2
2
2
2
Tray (tray) CW
3
3
4
2,250/4,000 lb CW
7018-6
FIGURE 6-20
4
To Next Page
Loading...
Need help?
General
