Manitowoc Grove TMS9000-2 Series User Manual

4-83
TMS9000-2 OPERATOR MANUAL OPERATING PROCEDURES
4
Published 02-21-2019, Control # 611-05
GROVE
be shown in the left margin of the operating display
(ODM).
Switching off the swing gear
If the swing gear is not required, it should be switched off to
avoid unintentional use.
• Press the button (1, Figure 4-170) once.
- The lamp in the button (1) will light up dimly.
- Symbol (2) will turn red if the swing gear is switched
off.
- The swing gear brake is applied – lamp (3) lights up.
Possible movement combinations
• The main hoist, telescoping mechanism, lifting/lowering
mechanism and swing gear can be operated in almost
any combination simultaneously. Restrictions are
specified for the specific power units.
• The auxiliary power units – Superstructure lock, tilt
crane cab, counterweight lifting unit – cannot be
operated with the Telescoping movement.
Moving the auxiliary power units in combination with
other power units can result in reductions of speed.
• Lattice extension lifting/lowering mechanism
The lattice extension lifting/lowering mechanism cannot
be operated in combination with the Extending
movement.
SETTINGS AND DISPLAYS FOR CRANE
OPERATION
This section only describes settings and displays needed
during crane operation. Operating elements that can be
assigned to other procedures are described with the
corresponding procedures.
Inclining the crane cab
With the appropriate equipment, you can incline the crane
cab to the rear in order to attain a better sitting position when
working at great heights.
NOTE: Prior to inclining the cab, make sure the door is
latched into position and that all loose items are
secured.
(A) – Raise the cab (Figure 4-171)
• Close the crane cab door.
• Push the button (1) down.
(B) – Lower the cab
• Close the crane cab door.
• Push the button (1) up.
The crane cab will tilt as long as you hold the button down or
until its end position is reached.
Switching units of measure
You can display the crane control values in metric units or
imperial units.
WARNING
Boom Damage Hazard!
Switching off the swing drive will activate the swing brake
immediately. If the crane is swinging, abrupt stopping will
create a shock load that could result in damage or
buckling of the boom. Death or Serious injury may occur.
8849-170a
FIGURE 4-169
8849-171
FIGURE 4-170
8849-172a
FIGURE 4-171

Manitowoc Grove TMS9000-2 Series Specifications

General

Brand	Manitowoc
Model	Grove TMS9000-2 Series
Category	Construction Equipment
Language	English