SET-UP AND INSTALLATION TMS9000-2 OPERATOR MANUAL
6-36
Published 02-21-2019, Control # 611-05
Unreeving hoist rope
• Pull out the rods (5, Figure 6-54) and (3).
• Fold down the plates (1).
• Remove the rope end fitting from the fixed point (2) or
(4).
• Unreeve the hoist rope.
• Insert the rods (5) and (3) and secure them.
Depending on the driving mode, you can:
- Fasten the hoist rope to the bumper, refer to Hook
block on the bumper, page 6-30 or
- Pull out the rods (1, Figure 6-55), (2) and roll the
hoist rope (3) on to the drum.
• Insert the rods (1), (2) and secure them.
• Secure the hoist rope (3).
Installing/removing the anti-two block
switch
For every reeved hoist rope, you must install a anti-two block
switch, attach a anti-two block switch weight and place it
around the hoist rope.
Installing the anti-two block switch
You can attach the anti-two block switch on the right or left
side of main boom head. Install the switch on the side that is
closer to the last rope line leading upwards. There can also
be one anti-two block switch installed on each side.
On the left side
• Plug the anti-two block switch (3, Figure 6-56) onto the
bracket (2) and secure it with the retaining pin.
• Lay the cable (4) in such a way that it will not be
damaged during crane operation, and insert the anti-two
block switch into the socket (1).
To Next Page
Loading...
Need help?
General
