To Next Page

To Previous Page

Software Installation &Maintenance 6-3

6.4 Software maintenance

6.4.1 Product Configuration

NOTE:

[Config] is available on the Maintenance menu only if the operator logged on the

system as Service.

1. Make PCF file according to the product (made in the factory, for special models, the PCF file is

already archived), then copy it to the USB disk. Insert the USB disk into the USB port; click

[Config] on the maintenance menu to open the following dialogue box.

2. Select correct PCF files, and click [OK]. After the operation is completed, the successful prompt

appears. Restart the system and the configuration takes effect.

Special configurations including:

Dedicated product LOGO, hospital LOGO, dormant/screen saver logo, image active/inactive

symbols in dual B mode, system information, system start-up/shut down screen, etc.

NOTE:

System general configuration is already configured during the resume

package restoration. No manual configuration is required if no special

requirement.

Don’t change the model of the machine; otherwise the key files may be lost.

6.4.2 Log Maintenance

6.4.2.1 Export the Log

NOTE:

This operation can be performed by both internal and external users.

Mindray DC-8 EXP Service Manual

Other manuals for Mindray DC-8 EXP