Mitsubishi Electric FR-F800 User Manual

165
5. PARAMETERS
5.4 (E) Environment setting parameters
3
4
5
5
5
6
7
8
9
10
 Reset limit function (P.E107)
• When P.E107 = "1" or Pr.75 = any of "100 to 103 and 114 to 117", if an electronic thermal O/L relay or an overcurrent
protective function (E.THM, E.THT, E.OC[]) is activated while one of them has been already activated within 3 minutes,
the inverter will not accept any reset command (RES signal, etc.) for about 3 minutes from the second activation.
• The reset limit function is available with the FR-F860-01080 or higher.
NOTE
• Resetting the inverter power (turning OFF the control power) will clear the accumulated thermal value.
• When the retry function is set enabled (Pr.67 Number of retries at fault occurrence  "0"), the reset limit function is
disabled.
Pr.67 Number of retries at fault occurrence page 242
Pr.79 Operation mode selection page 204
Pr.250 Stop selection page 550
Pr.551 PU mode operation command source selection page 214
5.4.3 PU display language selection
The display language of the parameter unit (FR-PU07) can be selected.
5.4.4 Buzzer control
The PU (operation panel or parameter unit) key sound and buzzer can be turned ON/OFF.
NOTE
• When the buzzer is set to ON, a warning sound will be audible when a fault occurs.
5.4.5 PU contrast adjustment
Contrast adjustment of the LCD of the LCD operation panel (FR-LU08) and the parameter unit (FR-PU07) can be performed.
Decreasing the setting value lowers the contrast.
The above parameter is displayed as a simple mode parameter only when the LCD operation panel (FR-LU08) and the
parameter unit (FR-PU07) are connected.
CAUTION
• Do not perform a reset while a start signal is being input. Doing so will cause a sudden start of the motor, which is dangerous.
Pr. Name Initial value Setting range Description
145
E103
PU display language selection — 0 Japanese
1 English
2German
3 French
4 Spanish
5 Italian
6Swedish
7Finnish
Pr. Name Initial value Setting range Description
990
E104
PU buzzer control 1 0 Turns the key sound and buzzer OFF.
1 Turns the key sound and buzzer ON.
Pr. Name Initial value Setting range Description
991
E105
PU contrast adjustment 58 0 to 63 0: Low  63: High
Parametersreferredto

Mitsubishi Electric FR-F800 Specifications

General

Brand	Mitsubishi Electric
Model	FR-F800
Category	Inverter
Language	English