203
5. PARAMETERS
5.6 (D) Operation command and frequency command
3
4
5
5
5
6
7
8
9
10
5.6 (D) Operation command and frequency command
Purpose Parameter to set Refer to
page
To select the operation mode Operation mode selection P.D000 Pr.79 204
To start up in Network operation mode
at power-ON
Communication startup mode
selection
P.D000, P.D001 Pr.79, Pr.340 213
To select the command source during
communication operation
Operation and speed command
sources during communication
operation, command source
selection
P.D010 to P.D013 Pr.338, Pr.339,
Pr.550, Pr.551
214
To prevent motor from rotating
reversely
Reverse rotation prevention
selection
P.D020 Pr.78 221
To set the frequency by pulse train
input
Pulse train input P.D100, P.D101,
P.D110, P.D111
Pr.291, Pr.384 to
Pr.386
222
To perform JOG operation JOG operation P.D200, P.F002 Pr.15, Pr.16 224
To control frequency with
combinations of terminals
Multi-speed operation P.D300 to P.D315 Pr.28, Pr.4 to Pr.6,
Pr.24 to Pr.27,
Pr.232 to Pr.239
226
To Next Page
Loading...
Need help?
General
