388
5. PARAMETERS
5.11 (A) Application parameters
5.11.3 Start count monitor
The inverter starting times can be counted.
Confirming the starting times can be used to determinate the timing of the maintenance, using as a reference for system
inspection or parts replacement.
• Every start signal input (the RUN signal ON) while the inverter output is stopped is counted as the inverter starting time.
• The lower four digits of the number of starting times is displayed in Pr.1410 Starting times lower 4 digits, and the upper
four digits of the number of starting times is displayed in Pr.1411 Starting times upper 4 digits.
• The maximum count is "99999999". When "99999999" is exceeded on the monitor, the monitor value is reset to "0".
• Any value can be set in Pr.1410 or Pr.1411. Set "0" to clear the number on the monitor.
• Starting during offline auto tuning is not counted.
• The counting is enabled even if the RUN signal is not assigned to an output terminal.
• For the RUN signal, refer to page 297.
• Starting during test operation (Pr.800 ="9") is not counted.
Pr. Name Initial value Setting
range
Description
1410
A170
Starting times lower 4 digits 0 0 to 9999 Displays the lower four digits of the number of the inverter
starting times.
1411
A171
Starting times upper 4
digits
0 0 to 9999 Displays the upper four digits of the number of the inverter
starting times.
Display data PU display
10000 Pr.1410 (Lower digits monitor)
Pr.1411 (Upper digits monitor)
100 Pr.1410 (Lower digits monitor)
Pr.1411 (Upper digits monitor)
STF
ON
ON ON ON ON
ON
ON ON ON
Start count
indication
Output
frequency
Time
1
2
RUN
3
4
To Next Page
Loading...
Need help?
General
