68P80801E30-A 5/1/2002 3-29
Gen 3 Site Controller System Manual Chapter 3 Pre-Installation
Recommended Tools, Equipment, and Parts
Recommended Tools,
Equipment, and Parts
Table 3-8 through Table 3-10 list the tools, test equipment and locally
procured parts that are required for the installation procedure. The model
numbers listed are recommended, but equivalent tools and equipment made
by other manufacturers are acceptable.
When selecting tools and equipment, always choose those which have
insulated grips and handles. This helps prevent potential injury resulting
from electrical shock.
Recommended Tools
Table 3-8 lists the recommended tools for installation. These are not
included as part of the site control equipment and must be procured locally.
All model numbers are Motorola part numbers, unless noted otherwise.
Table 3-8 Recommended tools for installation
Tool Model/type Supplier Purpose
banding cutter n/a locally procured n/a
cable crimp tool TBM5 S Thomas & Betts crimping lugs on
power cables
calculator n/a locally procured n/a
cart,
two-wheeled
(luggage type)
6680387A47 Motorola transportation of
tools and test
equipment
circuit cooler
spray
0180334B46 Motorola low temperature
alarm testing
cellular tool kit RPX4286A Motorola miscellaneous
tools
crimping tool 8-pin modular
cable
locally procured customizing T1
connections
digital level 24” w/module Pro Smartlevel antenna downtilt
measurements
To Next Page
Loading...
Need help?
General
