68P80801E30-A 5/1/2002 4-7
Gen 3 Site Controller System Manual Chapter 4 Installation
Intercabling Connections
Intercabling Connections
This section describes the cabling procedures for each of the intercabinet
connections.
For Single Rack, Redundant Controller GEN 4 EBTS, refer to the SRSC
GEN 4 EBTS section of the EBTS System Manual (6881099E10). For Single
Rack, Single Controller GEN 4 EBTS, refer to the SRSC GEN 4 EBTS
section of the EBTS System Manual (6881099E10).
Section Page This section . . .
Cavity Combining RFDS
Intercabinet Cabling
4-9 describes and lists cabling quantities and types
required for various Cavity Combining
systems
800 MHz Duplexed RFDS
Intercabinet Cabling
4-12 describes and lists cabling quantities and types
required for various 800 MHz Duplexed
systems
800 MHz Duplex Hybrid
Expansion RFDS
intercabinet cabling
4-13 describes and lists cabling quantities and types
required for various 800 MHz Duplex Hybrid
Expansion systems
800 MHz GEN 4 Duplexed
RFDS and 900 MHz
Duplexed RFDS
Intercabinet Cabling
4-14 describes and lists cabling quantities and types
required for various 800 MHz GEN 4 and 900
MHz Duplexed systems
5 MHz/1 PPS Intercabling 4-18 describes the 5 MHz/1 PPS connections
Ethernet intercabling 4-20.3 describes the Ethernet connections
Alarm Intercabling 4-20.6 describes the individual cabinet alarm
connections
Primary Control Channel
Redundancy Intercabling
4-20.14 describes the connection of the primary control
channel redundancy control cable from the
EAS/EAS2 to the RF Cabinet
GPS antennas 4-21 describes the connection of GPS antennas
Alarm system cabling 4-24 describes the connection of site and Power
Supply Rack alarm connections to the EAS/
EAS2
Site controller to telephone
network T1 cabling
4-28 describes T1 connections and settings made on
customer side of demarcation point
Site controller to telephone
network E1 cabling
4-32 describes E1 connections and settings made on
customer side of demarcation point
To Next Page
Loading...
Need help?
General
