AFP-3030 Programming Manual — P/N DOC-01-032:A 26/06/2015 55
Point Program PrealarmProgram
Detector Point Programming (4)
Press the MORE soft key on the Detector Point Programming (4) screen to display this screen.
Figure 3.40 More Detector Point Programming (4) Screen
Soft Keys
AAM OPERATION: Press this softkey to select YES or NO for detector AAM operation. If set
to
YES, the first CBE position in detector programming is set as the AAM zone. The AAM zone
will become active when a non-fire or fire alarm occurs on the detector. All other CBE zones
(positions 2 through 10) will only become active when a fire alarm occurs.
3.4.2 Module Point
Module point programming screens will display if a module point address is entered at the Point
Programming Menu (see
Figure 3.31 on page 46).
Module Point Programming (1)
Figure 3.41 Module Point Programming (1) Screen
Soft Keys
MODULE TYPE: Press the soft key to toggle between CONTROL and MONITOR.
TYPE CODE LABEL: Press this soft key to scroll through the point type choices: stop at the
appropriate selection.
To Next Page
Loading...
Need help?
General
