NNIFOR
ETMP ARUREET
METP1
METP2
:
:
:
N1AF
401.3
401.3
(F )
(F ) 3201(A/D)
WOL
:
N2AF821
:
SENSOR–B203(A/D)
(D/A)
1
AMTIO
V–D1 1 1060 –NTV HA–B
1
5
10
15
16
1 5 10 15 20 25 30 35 40
A present temperature and the FAN rotation are displayed.
If either [k] key or [l] key is pressed, the display data is refreshed.
[1-4] TEMPERATURE
Display Item Meaning
TEMP1 The temperature of the sensor on the panel side is displayed by the Fahrenheit (F).
TEMP2 The temperature conversion display is done with 10 bit the A/D input value of IF microcomputer.
It is displayed by both the Fahrenheit (F) and 8 bit A/D value.
Note: When temperature (F) of the sensor becomes more than a specified temperature, the
shutdown start of processing.
FAN1 The value of the FAN rotating state is displayed.
STOP: stopped, LOW: slow speed, HIGH: high speed.
FAN2 The value of the rotation state of FAN is displayed.
During a rotation of FAN, 8bit D/A value output from IF microcomputer is displayed.
It is displayed with OFF during a stop.
B-SENSOR
The value that indicated the degree of brightness input into an Room light sensor is displayed.
AD value when the output of the Room light sensor was input into IF microcomputer is displayed.
To Next Page
Loading...
Need help?
General
