11.5
REAR SUSPENSION
The dot is an indicator of
the HIGH position. The
sides are the LOW
position and the bottom
is the MEDUIUM
position.
FRONT TORQUE
ARM LIMITER
STRAP
ADJUSTMENT
One method of changing ski-to-snow pressure is to change the
length of the front torque arm limiter straps. The limiter strap
is normally mounted in the fully extended position. Both
limiter straps must be adjusted evenly and remain equal in
length to avoid improper Hi-Fax and track wear.
• Lengthening the straps decreases ski pressure under
acceleration.
• Shortening the straps increases ski pressure under
acceleration.
RMK Set up Recommendations for Optimum Performance
• DEEP POWDER SNOW:FTA in LOW position for
maximum lift and flotation
• POWDER-HARDPACK:FTA in STANDARD position
for overall handling and speed over snow.
• HARDPACK: FTA in HIGH position for increased
control and less transfer.
TORSION SPRING ADJUSTMENT
To adjust the rear torsion spring, rotate the adjuster cam to the
desired adjustment. The cam has three sides, LOW, MEDIUM
and HIGH.
HIGH
LOW
LOW
MEDIUM
LOW
MED
HIGH
To Next Page
Loading...
Need help?
General
