3.26
MAINTENANCE
SHOCKS
Use T-9 Metal Protectant (or equivalent) on shock absorber
shafts to help prevent corrosion.
BATTERY
Disconnect and remove the battery. Clean the terminals and
cables. Apply dielectric grease to the terminals. Store in a cool
dry place for storage.
REPLACEMENT
HEADLIGHT BULB REPLACEMENT
NOTE: Do not touch the bulb with your fingers. The
grease from body oil will cause a hot spot on the
bulb and cause bulb failure. If you do touch the bulb
clean the bulb with isopropyl alcohol.
EDGE HEADLIGHT BULB REPLACEMENT
1. Push in on the “PUSH” section of the plenum.
2. Slide the access panel down to gain access to the bulb.
3. Squeeze and move the bulb clip up.
4. Replace the bulb, clip and access panel.
IQ HEADLIGHT BULB REPLACEMENT
1. Unplug the headlight harness (1) form the bulb.
2. Remove the rubber boot (2) from the housing.
3. Pinch the ends of the spring (3) together and lift it until it
releases from the spring retainer.
4. Lift spring carefully around the wire harness and flip it to
the outside of the housing.
5. Grasp the bulb (4) by the metal base and carefully separate
the bulb from the harness.
6. Instal new bulb by the base and reverse the process for
installation.
IQ SNOW BEAM BULB REPLACEMENT
1. Twist the light base (5) counterclockwise and pull it out
from the housing.
2. Remove the rubber boot (6).
3. Remove the bulb (7) by pulling it straight out from the
housing.
4. Replace bulb with new and reverse the process for
installation.
PUSH
SLIDE
1
2
3
4
5
6
7
To Next Page
Loading...
Need help?
General
