Quantum DXi4700 User Manual

Chapter 9: Configuration
Replication Configuration
Quantum DXi4700 User’s Guide 253
To configure Accent:
1. To enable Accent, select the Enable Deduplication with Accent check box.
To disable Accent, clear the Enable Deduplication with Accent check box.
2. Click Apply.
Additional Information
l Click the Change Encryption Type link to change the OST data encryption type (see Data
Encryption on page 315).
l To use DXi Accent, you must install the Quantum OST Client Plug-in on the media server.
Replication Configuration
The Replication Configuration page allows you to configure and manage replication targets and allowed
replication sources on the DXi4700. A source sends replicated data to 1 or 2 targets, and a target receives
replicated data from up to 10 sources. A DXi4700 can act as both a source and a target.
Additional Information
l For more information about data replication, or to perform data replication, see Replication on
page 122.
l If the DXi is configured as a replication target and replication is performed across a public network,
with the source and target located behind NAT-enabled routers, you must specify a NAT IP address
for the DXi on the Network page (see Configuring Interface IP Addresses on page 295).
To access the Replication Configuration page, click the Configuration menu, and then click the
Replication tab (see Figure 159 below).
Figure 159: Replication Configuration Page

Quantum DXi4700 Specifications

General

Brand	Quantum
Model	DXi4700
Category	Storage
Language	English