Chapter 9: Configuration
PTT Configuration
Quantum DXi4700 User’s Guide 263
Additional Information
l Path to tape is available only on the DXi4700 Multi-Protocol configuration.
l DXi4700 Multi-Protocol supports a maximum of three tape devices.
l For information about working with storage servers and LSUs, see OST Configuration on page 231.
l NDMP backup jobs can take longer or fail altogether if media and tape drives are not in optimal
condition. Replace old media and clean the tape drives in the attached library.
l For detailed information about configuring and using OST path to tape, see the DXi-Series
NetBackup and Backup Exec OST Configuration Guide (6-67079).
Best Practices Guides
The following DXi Best Practices Guides are available at www.quantum.com/DXi4700BPG:
l Backup Exec from Veritas
l Data Protector from HP
l Data Protection Manager from Microsoft
l NetBackup from Veritas
l NetWorker from EMC
l Simpana from CommVault
l Tivoli Storage Manager from IBM
l Veeam Backup and Replication
To access the PTT page, click the Configuration menu, and then click the PTT tab.
The PTT page contains the following tabs:
l Physical Device Discovery below
Physical Device Discovery
The Physical Device Discovery page allows you to discover attached physical tape libraries and tape
drives. After you discover the libraries and drives, you can use them for path to tape data movement.
To access the Physical Device Discovery page, on the PTT page, click the Physical Device Discovery
tab (see Figure 164 on the next page).
To Next Page
Loading...
Need help?
General