Making Printer Settings Using the Control Panel
141
System Menu
You can set basic functions required to use the printer. The printer can be used
on factory default, but the configuration can be changed depending on the con-
dition of the user. The changed condition holds even if the printer is turned off.
Changing the system menu
Follow the procedure below to change the settings for E. Saver Timer.
A Press the {Menu} key.
The [Menu] screen appears.
B Press {U} or {T} key to display [System], and then press the {# Enter} key.
C Press {U} or {T} key to display [Energy Saver], and then press the {# Enter}
key.
D Press the {U} or {T} key to display [E. Saver Timer], and then enter {# En-
ter} Key
E Press {U} or {T} key to select the lead time needed to switch to the En-
ergy Saver mode.
F Press the {# Enter} key.
Wait for two seconds. The [Energy Saver] screen appears.
G Press the {On Line} key.
The initial screen appears.
System menu parameters
This section explains about parameters that can be set on the System menu.
To Next Page
Loading...
Need help?
General