Monitoring and Configuring the Printer
221
❒ For details about UNIX commands and parameters, see UNIX Supplement.
❒ For details about mshell prnlog commands, see p.195 “
prnlog”.
Configuring the Network Interface Board
Use the following command to display network interface board settings:
• telnet : Use the “show” command.
Result Print Request Result
Communication Result
•OK
Print was completed normally. However, the print result may
not be as required due to printer problems.
•NG
Printing was not completed normally.
• Canceled
An “rcp”, “rsh”, or “lpr” command print request was canceled,
possibly due to the printing application. Not applicable to the
“ftp” or “rprinter” command.
Time Time the print requested was received.
Time of print request reception
User ID Printer driver-configured User ID.
Appears when the print request ID is specified.
JobName Name of the document for printing
Appears when the print request ID is specified.
Item Description
Common
mode
Protocol Up/Down [up] means “active” and [down] means “inactive”.
appletalk
TCP/IP
netware
SMB
IP over 1394
SCSI print
Ethernet interface Internal version number
Syslog priority
NVRAM version Internal version number
Item Description
To Next Page
Loading...
Need help?
General