Monitoring and Configuring the Printer
191
❖ Configuration
msh> hostname “interface_name” “printer_name”
• Enter the printer name using up to 63 alphanumeric characters.
• You cannot use a printer name starting with “RNP” or “rnp”.
• The Ethernet interface and IEEE 802.11b interface will have the same
printer name.
• ip1394 can be specified only when the IEEE 1394 interface is installed.
• wlan can be specified only when the IEEE 802.11b interface is installed.
❖ Initializing the printer name for each interface
msh>hostname interface_name clear name
ifconfig
Use the “ifconfig” command to configure TCP/IP (IP address, subnet mask,
broadcast address, default gateway address) for the printer.
❖ View settings
msh> ifconfig
❖ Configuration
msh> ifconfig “interface_name” “parameter” “address”
• If you did not enter an interface name, it is automatically set to the Ethernet
interface.
• ip1394 can be specified only when the IEEE 1394 interface is installed.
• wlan can be specified only when the IEEE 802.11b interface is installed.
❖ Netmask configuration
msh> ifconfig “interface_name” netmask “address”
❖ Broadcast address configuration
msh> ifconfig “interface_name” broadcast “address”
Interface name Interface configured
ether Ethernet interface
ip1394 IEEE 1394 interface
wlan IEEE 802.11b interface
Interface name Interface configured
ether Ethernet Interface
ip1394 IEEE 1394 Interface
wlan IEEE 802.11b Interface
To Next Page
Loading...
Need help?
General