Configuration
66
5
IEEE 802.11b (Wireless LAN) Configuration
Configure the printer to use IEEE
802.11b (Wireless LAN). The follow-
ing table shows the control panel set-
tings and their default values. These
items appear in the [Host Interface]
menu.
Note
❒ To use IEEE 802.11b (Wireless
LAN), select [IEEE 802.11b] for [LAN
Type] in [Network Setup] in the [Host
Interface] menu, and then set [IP Ad-
dress], [Subnet Mask], [Gateway Ad-
dress], [DHCP], [Frame Type (NW)]
and [Active Protocol] under the [Net-
work Setup] menu. For details about
setting items under “Configuring
the Printer for the Network”, see
Software Guide.
❒ The 802.11b interface unit cannot
be used simultaneously with a
standard ethernet interface.
❒ In the [SSID] menu, if blank is spec-
ified in 802.11b Ad hoc mode or
Ad hoc mode, [ASSID] appears.
A Press the {Menu} key.
The [Menu] screen appears on the
display.
B Press the {U} or {T} key to dis-
play [Host Interface], and then press
the {# Enter} key.
The interface setting menu ap-
pears.
C Press the {U} or {T} key to dis-
play [IEEE 802.11b] , and then press
the {# Enter} key.
The IEEE 802.11b setting menu ap-
pears.
D Press the {U} or {T} key to dis-
play [Comm. Mode], and then press
the {# Enter} key.
Setting Name Default Value
Comm. Mode 802.11 Ad hoc
Channel Inch version
(1-11) 11
Metric version
(1-13) 13
Trans. Speed Auto
SSID blank (ASSID)
WEP Setting Not Active
Menu:
Host Interface
AGN200S
KirP4GB_Setup-F4_FM_forPaper.book Page 66 Wednesday, December 8, 2004 6:05 AM
To Next Page
Loading...
Need help?
General