Attaching 1394 Interface Unit Type 4510
39
3
Attaching 1394 Interface Unit Type 4510
CAUTION:
Important
❒ The 1394 interface unit uses “IP
over 1394” and “SCSI print”. Oper-
ating system-compatible connec-
tion methods are as follows (IEEE
1394 cannot be used with Win-
dows 95/98 and Windows NT 4.0):
•Windows Me
“IP over 1394”
• Windows 2000
“SCSI print”
• Windows XP,
Windows Server 2003
“IP over 1394”, “SCSI print”
❒ Under Windows 2000, the 1394 in-
terface unit can only be used with
Service Pack 1 or later. The client
cannot install the printer driver
without using an account that has
administrators access rights.
❒ Before touching the 1394 interface
unit, ground yourself by touching
something metal to discharge any
static electricity. Static electricity
can damage the 1394 interface unit.
❒ Do not plug or unplug the 1394 in-
terface cable while installing the
printer driver.
❒ Use the 1394 interface cable that
comes with 1394 interface unit.
A Check the package contains the
following:
❖ 1394 Interface Unit Type 4510
❖ 1394 Interface Cable
(6 pins x 4 pins)
❖ 1394 Interface Cable
(6 pins x 6 pins)
• Do not touch the inside of the
controller board compartment.
Doing so may cause a malfunc-
tion or a burn.
ZKDP400J
ZKDP993J
ZKDP992J
KirP4GB_Setup-F4_FM_forPaper.book Page 39 Wednesday, December 8, 2004 6:05 AM
To Next Page
Loading...
Need help?
General