Configuration
70
5
IEEE 1394 Configuration
Use this procedure to configure the
printer for use in an IEEE 1394 envi-
ronment. The following table shows
the control panel settings and their
default values. These items appear in
the [Host Interface] menu.
Note
❒
If DHCP is in use, “IP Address1394”
and “Subnet Mask1394” are auto-
matically set.
IP over 1394
A Press the {Menu} key.
The [Menu] screen appears on the
display.
B Press the {U} or {T} key to dis-
play [Host Interface], and then press
the {# Enter} key.
The interface setting menu ap-
pears.
C Press the {U} or {T} key to dis-
play [IEEE 1394 Setup], and then
press the {# Enter} key.
The IEEE 1394 setting menu ap-
pears.
D Press the {U} or {T} key to dis-
play [IP over 1394], and then press
the {# Enter} key.
The IP over 1394 setting menu ap-
pears.
Setting Name Value
DHCP On
IP Address1394 011.022.033.044
Subnet Mask1394 000.000.000.000
IP over 1394 Active
SCSI print Active
Bidi-SCSI print On
Menu:
Host Interface
AGN200S
KirP4GB_Setup-F4_FM_forPaper.book Page 70 Wednesday, December 8, 2004 6:05 AM
To Next Page
Loading...
Need help?
General