Monitoring and Configuring the Printer
212
Getting Printer Information over the
Network
This section explains details of each item displayed in the printer status and in-
formation.
Current Printer Status
The printer status can be checked using the following commands:
• UNIX: Use the “lpq” command and “rsh”, “rcp”, and “ftp” parameters.
• mshell: Use the “status” command.
Messages Description
Access Restricted The job was canceled because user have no
authority.
Add staples (Booklet: Back) The staple of booklet finisher (back) is ex-
hausted.
Add staples (Booklet: Both) The staple of booklet finisher is exhausted.
Add staples (Booklet: Front) The staple of booklet finisher (front) is exhaust-
ed.
Adjusting... The machine is initializing or calibrating.
Call Service Center There is a malfunction in the machine.
Canceled The job is reset.
Canceling Job... The job is being reset.
Card/Counter not inserted The machine is waiting for prepaid card or key.
Coin or amount not inserted The machine is waiting for coin to be inserted.
Coin/Key Counter not inserted The machine is waiting for coin or key counter.
Configuring... Setting is being changed.
Cover Open: ADF The document feeder is open.
Cover Open: Duplex Unit The cover of the duplex unit is open.
Cover Open: Finisher The cover of Finisher is open.
Cover Open: Front The front cover is open.
Cover Open: Front/Left The front cover or left cover is open.
Cover Open: Paper Exit / Rear The paper exit cover or rear cover is open.
Cover Open: Right The right cover is open.
Cover Open: Top The top cover is open.
Data Size Error The data size error occurred.
To Next Page
Loading...
Need help?
General