• The scanned files to the destinations specified from the LDAP server will be created with the
machine's current scan settings. If necessary, configure the scan settings before executing scanning.
• If a record that has been found contains multiple destinations, the first of those destinations will be
used.
• For details about registering LDAP servers, see p.440 "Programming the LDAP server".
• For details about specifying the search conditions, see p.446 "Specifying the LDAP Address
Search Conditions".
• For details about [Scanning Mode], see p.263 "Scanner Settings".
• To configure advanced scan settings, see p.191 "Specifying the Scan Settings".
Basic Operation for Scan to USB
This section describes the basic operation for sending scanned files to a USB flash disk.
• The original in the ARDF or ADF takes precedence over the original on the exposure glass if you
place originals both in the ARDF/ADF and on the exposure glass.
• This machine does not support the use of USB flash disks connected to external USB hubs. Insert
your USB flash disk directly into the USB flash disk port located at the top left corner of the
machine.
• Certain types of USB flash disks cannot be used.
• If [Save Scn Data to USB] under administrator settings is disabled, this function cannot be used.
1. Insert your USB flash disk into the USB flash disk port.
To Next Page
Loading...
Need help?
General
