The machine recovers from Energy Saver mode when it receives a print job, prints a received fax, or
when the [Copy] or [Start] key is pressed.
Energy Saver mode 1
If [EnergySaverMode 1] under [Admin. Tools] is enabled, the machine enters Energy Saver mode
1 if the machine has been idle for about 30 seconds. When the machine is in Energy Saver mode
1, "Energy Saver Mode 1" appears on the screen. It takes less time to recover from Energy Saver
mode 1 than from power-off state or Energy Saver mode 2, but power consumption is higher in
Energy Saver mode 1 than in Energy Saver mode 2.
Energy Saver mode 2
If [EnergySaverMode 2] under [Admin. Tools] is enabled, the machine enters Energy Saver mode
2 after the period of time specified for this setting is passed. When the machine is in Energy Saver
mode 2, the screen turns off while the Power indicator remains lit. Power consumption is lower in
Energy Saver mode 2 than in Energy Saver mode 1, but it takes longer to recover from Energy
Saver mode 2 than from Energy Saver mode 1.
• Even if Energy Saver mode 2 is enabled, the machine will not enter Energy Saver mode 2 for two
hours if [Low Humidity Mode] under [System Settings] is enabled. However, the machine will enter
Energy Saver mode 1 as normal (even when Energy Saver mode 1 is not enabled).
• For details about Energy Saver modes, see p.298 "Administrator Settings".
• For details about [Low Humidity Mode], see p.279 "System Settings".
Multi-access
This machine can perform multiple jobs using different functions, such as copying and faxing, at the
same time. Performing multiple functions simultaneously is called “Multi-access”.
The following table shows the functions that can be performed simultaneously.
Current job Job that you want to execute simultaneously
Copying
• Fax memory transmission
• Fax memory reception
• Internet Fax reception (no printing)
• Receiving a print job from a computer (the actual printing starts
after copying is finished)
• Receiving a LAN-Fax job from a computer
• LAN-Fax transmission
Installing the Machine
61
To Next Page
Loading...
Need help?
General
