Basic Operation for Sending a Fax
This section describes the basic operation for sending a fax.
• The original in the ARDF or ADF takes precedence over the original on the exposure glass if you
place originals both in the ARDF/ADF and on the exposure glass.
1. Press the [Facsimile] key.
2. Place the original on the exposure glass or in the ARDF/ADF.
If necessary, configure the advanced scan settings.
3. Enter the fax number (up to 40 characters) using the number keys, or specify a
destination using the One Touch buttons or Speed Dial function.
• If the machine is connected to the telephone network through a PBX, make sure to enter the
outside line access number specified in [PBX Access Number] before the fax number.
• To specify an Internet Fax destination, use the One Touch buttons or Speed Dial function.
4. Press the [Start] key.
• Depending on the machine's settings, you may be prompted to enter the fax number again if
you manually entered the destination fax number. In this case, re-enter the number within 30
Sending a Fax
211
To Next Page
Loading...
Need help?
General
