20/617
Building Technologies Division User Manual LMS14... CC1U7471en
2 Safety notes 28.01.2015
2.5 Typographical conventions
2.5.1 Safety notes
This User Manual contains instructions which must be observed to ensure your
personal safety and to prevent damage to equipment and property. The instructions
and notes are highlighted by warning triangles, arrows or information symbols and are
presented as follows, depending on the hazard level:
Danger
means that death, severe personal injury or substantial
property damage will occur if adequate precautionary
measures are not taken.
Warning
means that death, severe personal injury or substantial
property damage can occur if adequate precautionary
measures are not taken.
Caution
means that minor personal injury or property damage
can occur if adequate precautionary measures are not
taken.
Note draws your attention to important information on the
product, on product handling, or to a special part of the
documentation.
Reference refers to further information given in other pieces of
documentation or in chapters of this document.
Only qualified personnel are allowed to install and operate the equipment. Qualified
personnel in the context of the safety-related notes contained in this document are
persons who are authorized to commission, ground and tag devices, systems and
electrical circuits in compliance with established safety practices and standards.
Note the following:
The LMS14… may only be used on applications covered by the technical description.
The use of unsuitable or incorrectly installed accessories can lead to personal injury or
damage to property.
When using the unit in connection with third-party products or components, following
must be noted:
- The technical data of the LMS14… must be observed; in addition to static data,
consideration must be given to dynamic data, such as switch-on and switch-off
currents, surge currents, etc.
- EMC-specific properties or retroactive effects can adversely affect the unit’s life and
reliability and must be checked by the customer
- The OEM as the system integrator must ensure compliance with the relevant
regulations and make certain the correct fuses are used
- Siemens assumes no responsibility for the system
The products can only function correctly and safely if shipped, stored, set up and
installed correctly, and operated and maintained as specified.
Qualified personnel
Correct use
To Next Page
Loading...
Need help?
General
