495/617
Building Technologies Division User Manual LMS14… CC1U7471en
6 The settings in detail 28.01.2015
6.28.5 Spare part business
The OEM sets the parameters of the units on the production line, based on the
parameter sets defined by him. The parameter sets contain unambiguous settings of
the parameter set numbers and OEM parameter set numbers. Here, the groupings
according to OEM parameter set group numbers and OEM boiler type should also be
made.
If replacement units were programmed with a Siemens data set and an OEM-specific
data set shall be transferred, the compatibility checks for the data set must be
deactivated. This means that neither the parameter version number nor the OEM
parameter version number are checked before the data set is transferred to the
LMS14... As a result, there is a risk that this data set is inadvertently transferred to
other units as well. Also refer to the description given in chapter Examples of potential
risks.
To reduce potential risk, the OEM must also supply replacement units with company-
specific basic parameter settings. This parameter set is then used to generate the stick
data sets.
If required, it is possible to deactivate checking of certain parameters in the data sets
and to set these data to new values.
To Next Page
Loading...
Need help?
General
