Siemens SIMOTION D410-2 DP User Manual

Inserting a further SIMOTION device
If
you insert a further SIMOTION device using "Insert SIMOTION device", the PG/PC interface
selection dialog box is not displayed. The second SIMOTION device is automatically
connected to the PG/PC via Ethernet and a new unique IP address (last digit + 1 up to 255)
is calculated.
Additional references
Further information on the topic of "Going online" can be found
● In the online help via the "Contents" tab at
– "Diagnostics" > "Overview of service and diagnostics options" > "Part III" > "Go online"
– "Insert device and connect to target system" > "Go online/offline"
● On the Internet at Internet address (
http://support.automation.siemens.com/WW/view/en/
22016709)
●
In SIMOTION Utilities & Applications, FAQ "Online connections to SIMOTION devices".
SIMOTION Utilities & Applications is part of the scope of delivery of SIMOTION SCOUT.
6.2.4 Display of the SIMOTION D410-2 in HW Config
Once you have created a project and inserted a SIMOTION D410‑2 as module, HW Config
opens automatically (if parameterized).
In HW Config, the SIMOTION D410‑2 is displayed with the SINAMICS Integrated and the
interfaces.
Parameter assignment / addressing
6.2 Creating a project and configuring the communication
SIMOTION D410-2
110 Commissioning and Hardware Installation Manual, 01/2015

Siemens SIMOTION D410-2 DP Specifications

General

Brand	Siemens
Model	SIMOTION D410-2 DP
Category	Controller
Language	English